Readers ask: How To Cut Plywood Straight?

What is the best tool to cut plywood?

Most projects that involve plywood require cutting to size. Many homeowners wonder what the best way to cut plywood is. You can cut plywood with a handsaw, jigsaw, table saw or circular saw.

How do you cut plywood smoothly?

Use the right blade, and use it properly. For circular saws, grab a $15-20 carbide tip blade designed for plywood. For table and miter saws, invest in an 80 TPI plywood blade, one designed for cross (miter saw) or rip (table saw) cuts. Then when making your cuts, set yourself up for success.

How do you cut plywood without splintering?

How to Avoid Splintering and Tearing when Cutting Plywood

  1. Always use an appropriate blade for plywood, and be sure that it’s sharp.
  2. Be sure the good face of your plywood is closer to the outside of the blade.
  3. Then, add a strip of masking tape to both the top and bottom of the sheet, directly over the cut line.

Can you cut plywood with a jigsaw?

The jigsaw can be used to make both straight and curved cuts in a wide variety of materials, including wood, particleboard, plywood, plastic, metal, even ceramic tile.

You might be interested:  Question: What Type Of Plywood For Subflooring?

Can you cut plywood with scissors?

Scissors. Scissors are one overlooked woodworking tool. This large tool, sometimes over 12 inches in length, can cut through plywood up to 1/8 inch thick, or even hardwood if it is planed down to 1/8 inch.

Can you cut plywood with a Dremel?

When using the Dremel as a router, you can make rabbet cuts, cut molding onto the edges of boards, cut slots into pieces of plywood, chamfer and round edges. These are smaller cuts than you would normally make with a router, as the size of the bits is smaller. Nevertheless, for detail work, they are ideal.

What side do you cut plywood?

The bottom edge usually remains splinter-free. So always cut plywood with the good side down.

How do you cut a straight line without a table saw?

For cutting a board lengthwise, if the board has no true edge to begin with, turn to a tracksaw, or a circ saw with a straightedge guide. If the workpiece has a straight “factory” edge already, as sheet goods do, an edge guide may be a better choice [Photo A].

Leave a Reply

Your email address will not be published. Required fields are marked *