Question: What Circular Saw Blade For Plywood?

What saw blade for plywood?

To get the best-quality cuts, invest in an 80-tooth blade designed for sheet goods. The small teeth take little bites to reduce chip-out and are steeply beveled at their edges to score the veneer face. You’ll have to slow your feed rate, but will get a much smoother edge.

How many teeth should a circular saw plywood blade have?

A 40-tooth blade works fine for most cuts through plywood. Blades with 60 or 80 teeth should be used on veneered plywood and melamine, where the thin veneers are likely to blow out on the underside of the cut, a characteristic known as tearout. MDF requires even more teeth (90 to 120) to get the cleanest cut.

Is a circular saw good for cutting plywood?

Make circular saw cuts so clean that you don’t have to sand or touch up the plywood edges. We show you out seven best tips for making smoother, straighter and more accurate cuts on big sheets of plywood. Your circular saw can cut just as well as a table saw.

How do I choose a circular saw blade for wood?

The characteristics that determine the function a circular saw blade are:

  1. Number of Teeth. Generally, blades with more teeth will provide a smoother, finer cut whereas blades with fewer teeth will provide a rougher cut.
  2. Gullet Size.
  3. Hook or Rake Angle.
  4. Bevel Angle.
  5. Kerf.
  6. Rip Blades.
  7. Crosscut Blades.
  8. Concrete Reasoning?
You might be interested:  What Type Plywood For Flooring?

What’s the best saw for cutting plywood?

If you want to cut plywood into a circle or intricate pattern, a jigsaw will be your best bet. Jigsaws can also make straight cuts, but it’s more difficult. Always make sure the jigsaw’s cord has enough length to reach where you’re cutting.

Is more teeth on a saw blade better?

The number of teeth on the blade helps determine the speed, type and finish of the cut. Blades with fewer teeth cut faster, but those with more teeth create a finer finish. Gullets between the teeth remove chips from the work pieces.

How long does a circular saw blade last?

They can last between 12 and 120 hours of continuous use, depending on the quality of the blade and material they’re used to cut.

How do you cut a plywood with a circular saw without splintering?

How to Avoid Splintering and Tearing when Cutting Plywood

  1. Always use an appropriate blade for plywood, and be sure that it’s sharp.
  2. Be sure the good face of your plywood is closer to the outside of the blade.
  3. Then, add a strip of masking tape to both the top and bottom of the sheet, directly over the cut line.

How do you keep plywood from chipping when cutting?

11 Tips On How To Cut Plywood Without Chipping

  1. Purchase an 80-tooth saw blade.
  2. Use painters tape or frog tape.
  3. Keep your pieces supported on the table saw.
  4. Supporting pieces if using a circular saw can be achieved by using a piece of rigid insulation.
  5. If using a table saw keep the stock pushed tightly into the fence.
You might be interested:  How Much Is 5 8 Cdx Plywood?

Can I cut plywood with a jigsaw?

The jigsaw can be used to make both straight and curved cuts in a wide variety of materials, including wood, particleboard, plywood, plastic, metal, even ceramic tile.

Leave a Reply

Your email address will not be published. Required fields are marked *