Often asked: How To Install Hardwood Flooring On Plywood?

Can you install hardwood floor over plywood?

This flooring can be installed over old wood flooring or over a plywood sub-floor. A minimum 3/4-inch-thick sub-floor is required. If you are working atop a single plywood layer, we recommend adding a second layer of 1/4- to 1/2-inch plywood or commercial floor substrate material.

Do I need underlayment for hardwood flooring on plywood?

The short answer: usually. If you already have a plywood subfloor, and the subfloor is smooth and level, then you may not need an underlayment beneath the hardwood floor. Plywood has some moisture resistance already compared to solid wood, and it mostly gives a smooth surface.

What do you put under hardwood flooring?

Red Rosin Paper or Builder’s Felt Paper or felt are two materials that are traditionally installed between hardwood flooring and the subfloor. These materials help minimize squeaking that may occur between the bottom of the floorboards and the top of the subfloor.

What is the recommended underlayment for hardwood flooring?

What Underlayment is Best for Wood? When installing hardwood or engineered wood flooring, the best underlay options are cork and foam. However, foam does have more give than cork so, while it is the more popular option, we recommend cork. Cork has less give, making it less likely to flex underneath your planks.

You might be interested:  Quick Answer: What Is Better For Subfloor Osb Or Plywood?

Do I need to put anything under hardwood flooring?

Why You Need Underlayment While underlayment isn’t always necessary for your hardwood floors, there are always benefits to it. One of the most significant reasons to install underlayment is the added stability and durability. Underlayment provides support for your floor and helps smooth subfloor imperfections.

Do I need a moisture barrier on wood subfloor?

Wood Subfloors Sometimes, a moisture barrier is not recommended. If you’re installing your hardwood floors over a wood subfloor, you should avoid using a moisture barrier. Over time, moisture can get trapped between the moisture barrier protecting your hardwood flooring and the wood subfloor.

Do you need moisture barrier under hardwood flooring?

Do I need a vapor barrier for hardwood floors?” The answer is YES! Moisture can destroy hardwood flooring. It causes cupping, warping, and even mildew if not treated. You must install a moisture barrier to protect your flooring from water wicking up from below.

Do prefinished hardwood floors scratch easily?

You can walk on your new prefinished floor immediately. Even though the floor may be dry to the touch, it will be vulnerable to scraping until the waiting time has elapsed and the finish has fully cured.

Should you lay plywood over plank subfloor?

Take time to make sure your existing planks are well secured in place. Repair any broken planks. Install a layer of at least ½” or preferably 5/8” ply over the existing planks. Like all wooden flooring products, it’s a good idea to acclimatise your plywood before laying it.

Can you put hardwood flooring over subfloor?

Subfloors, such as vinyl, carpet, concrete, or ceramics cannot support a solid hardwood installation and should be removed before you install.

You might be interested:  Question: How To Paint Plywood Ege Aft E Rrouting?

What is the best time of year to install hardwood floors?

The best seasons of the year for hardwood floor installation are the spring and fall, when there is a moderate amount of moisture in the air but the climate is not overly damp. Whenever you decide to have the floor installed, an indoor humidity level between 45-65 percent is recommended.

Can you walk on hardwood floors after installation?

How long do I have to wait to use my room after new floors are installed? We recommend waiting 6 hours before walking on your new floors in socks. After 24 hours you can walk through with shoes on. Allow 48 hours before setting furniture and returning pets.

Leave a Reply

Your email address will not be published. Required fields are marked *